Ingersoll lawn tractors 3012
Power
12 hp
Production
1989-1993
Engine
Gasoline, 2-cylinder
Transmission
Hy-Drive
Weight
683 lbs [309 kg]
Drive
2WD
From the same series:
Introduction
Production Information of Ingersoll lawn tractors, 3012
The production information of the tractor (3012) includes details about its manufacturing.
| Garden tractor |
| Built in Winneconne, Wisconsin, USA |
| Manufacturer | Ingersoll |
|---|
Dimension and Tires Information of Ingersoll lawn tractors, 3012
This section sums up the dimension and tires information of the tractor.
| Clearance (rear axle) | 7.2 inches [18 cm] |
|---|---|
| Wheelbase | 46 inches [116 cm] |
| Height (hood) | 35.5 inches [90 cm] |
| Height (steering wheel) | 40 inches [101 cm] |
| Length | 65 inches [165 cm] |
| Front tread | 28.75 inches [73 cm] |
| Weight | 683 lbs [309 kg] |
| Width | 37 inches [93 cm] |
| Rear tread | 27.75 inches [70 cm] |
No data available
Engine Specifications of Ingersoll lawn tractors, 3012
Get the specifications for the engine and if different options are available.
| Briggs & Stratton 294447 |
| Air-cooled horizontal-shaft |
| The Briggs Vanguard engine was used on the 3012 beginning in 1991, tractor serial number 14145700. |
| Gasoline |
| 2-cylinder |
| Intake valve clearance | 0.009 inches (cold) [0.229 mm] |
|---|---|
| Exhaust valve clearance | 0.005 inches (cold) [0.127 mm] |
| Power (gross) | 12 hp [8.9 kW] |
| Exhaust valve clearance | 0.018 inches (cold) [0.457 mm] |
| Starter | Electric |
| Starter volts | 12 |
| Rated RPM | 3600 |
| Bore/Stroke | 2.677x2.60 inches [68 x 66 mm] |
| Displacement | 480 cc [29.3 ci] |
| Intake valve clearance | 0.005 inches (cold) [0.127 mm] |
| Sparkplug gap | 0.030 inches [0.762 mm] |
| Sparkplug | Champion RC12YC |
Transmission Information of Ingersoll lawn tractors, 3012Y
Discover all variants of transmission available for this tractor model.
Transmission variants 1
| Transmission | Hy-Drive |
|---|---|
| Type | Hydraulic drive |
| Gears | Infinite forward and reverse (2-range) |
Mechanical Specs of Ingersoll lawn tractors, 3012Y
This section summarizes all mechanical information such as the brake system and other specifications.
| Two-wheel drive |
| Open operator station. |
| Manual steering |
| Mechanical band brakes |
Power Information of Ingersoll lawn tractors, 3012Y
Discover the power specifications and options available for this tractor model but also PTO (Power Take-off) information.
| Front PTO | Independent |
|---|---|
| Clutch | Electric |
| Front PTO Type | Pulley |
Hydraulics Specifications of Ingersoll lawn tractors, 3012
Hydraulic system type, pressure, pump flow and valves.
| Type | Open center |
|---|---|
| Valves | 2 |
| 575 psi (lift) [39.6 bar] | |
| Capacity | 1.5 gal [5.7 L] |
| Pump flow | 8 gpm [30.3 lpm] |
| Pressure | 2000 psi (transmission) [137.9 bar] |
Three-Point Hitch of Ingersoll lawn tractors, 3012
Hitch category and rear/front lift capacity.
| Rear Type | 0 OptOptional |
|---|---|
| Type | Sleeve hitch OptOptional |
Electrical System of Ingersoll lawn tractors, 3012
Battery voltage, charging system and ground.
| Ground | Negative |
|---|---|
| Battery volts | 12 |
| Battery CCA | 230 |
| Charging system | Flywheel alternator |
| Battery AH | 32 |
| Charging amps | 15 |
Frequently asked questions
How much horsepower does the Ingersoll lawn tractors 3012 have?
The Ingersoll lawn tractors 3012 delivers 12 HP.
What years was the Ingersoll lawn tractors 3012 produced?
The Ingersoll lawn tractors 3012 was produced in 1989-1993.
What engine does the Ingersoll lawn tractors 3012 have?
The Ingersoll lawn tractors 3012 is powered by a Gasoline, 2-cylinder engine.
What transmission does the Ingersoll lawn tractors 3012 use?
The Ingersoll lawn tractors 3012 uses a Hy-Drive transmission.
How much does the Ingersoll lawn tractors 3012 weigh?
The Ingersoll lawn tractors 3012 weighs 683 lbs [309 kg].
Is the Ingersoll lawn tractors 3012 4WD?
The Ingersoll lawn tractors 3012 is available in 2WD.