Introduction
Production Information of John Deere, 5103
The production information of the tractor (5103) includes details about its manufacturing.
| Utility tractor |
| Built in Pune, Maharashtra, India |
| Manufacturer | John Deere |
|---|
Dimension and Tires Information of John Deere, 5103
This section sums up the dimension and tires information of the tractor.
| Wheelbase | 80.7 inches [204 cm] |
|---|---|
| Rear tread | 55.8 to 71.7 inches [141 to 182 cm] |
| Clearance (front axle) | 18 inches [45 cm] |
| Front tread | 56.9 to 81.9 inches [144 to 208 cm] |
| 2WD Ag front | 7.5-16 |
|---|---|
| 4WD Ag front | 8.3-24 |
| Ag rear | 13.6-28 |
Engine Specifications of John Deere, 5103
Get the specifications for the engine and if different options are available.
| Liquid-cooled |
| The John Deere 5203 was naturally-aspirated until engine serial number 106597. Engines from that point on were turbocharged. |
| Coolant capacity | 10 qts [9.5 L] |
|---|---|
| Starter volts | 12 |
| Power | 50 hp [37.3 kW] |
| Coolant change | 2000 h |
| Compression | 17.8:1 |
| Rated RPM | 2400 |
| Air cleaner | Dry |
| Bore/Stroke | 4.19x4.33 inches [106 x 110 mm] |
| Oil capacity | 9 qts [8.5 L] |
| Oil change | 100 h |
| Displacement | 179 ci [2.9 L] |
| Firing order | 1-2-3 |
| Intake valve clearance | 0.014 inches [0.356 mm] |
| Exhaust valve clearance | 0.018 inches [0.457 mm] |
| Operating RPM | 1400-2400 |
| Idle RPM | 800-2650 |
Transmission Information of John Deere, 5103Y
Discover all variants of transmission available for this tractor model.
Transmission variants 1
| Three speeds (1-3) plus reverse (R) in three ranges (A-C). Tractor must be stopped, and clutch used, before shifting speed or range. Standard on 2WD models. |
| Transmission | SyncReverser |
|---|---|
| Oil capacity | 40 qts [37.9 L] |
| Gears | 9 forward and 3 reverse |
| Clutch | Dry disc |
Transmission variants 2
| The SyncShuttle (also identified as Top Shaft Synchronizer or TSS) is available on the 4WD models. Three speeds (1-3) plus reverse (R) in three ranges (A-C). Shifting speeds may be done while in motion, using the clutch. The tractor must be stopped to shift ranges. |
| Transmission | SyncShuttle |
|---|---|
| Oil capacity | 40 qts [37.9 L] |
| Clutch | Dry disc |
| Type | Partially synchronized |
| Gears | 9 forward and 3 reverse |
| 9-speed |
| 9-speed partially synchronized |
Mechanical Specs of John Deere, 5103Y
This section summarizes all mechanical information such as the brake system and other specifications.
| Two- or four-wheel drive |
| Foldable two-post ROPS. |
| Power steering |
| Differential wet disc brakes |
Power Information of John Deere, 5103Y
Discover the power specifications and options available for this tractor model but also PTO (Power Take-off) information.
| Rear PTO | Independent |
|---|---|
| Rear PTO Type | 540 |
| Engine RPM | 540@2400 |
Hydraulics Specifications of John Deere, 5103
Hydraulic system type, pressure, pump flow and valves.
| Steering flow | 6.8 gpm [25.7 lpm] |
|---|---|
| Type | Open center |
| Pump flow | 9.5 gpm [36.0 lpm] |
| Valves | 1 to 2 |
| Capacity | 10 gal [37.9 L] |
| Total flow | 16.3 gpm [61.7 lpm] |
| Pressure | 2800 psi [193.1 bar] |
Three-Point Hitch of John Deere, 5103
Hitch category and rear/front lift capacity.
| Rear Type | I/II |
|---|---|
| Rear lift | 3591 lbs [1628 kg] |
Electrical System of John Deere, 5103
Battery voltage, charging system and ground.
| Ground | Negative |
|---|---|
| Battery volts | 12 |
| Battery CCA | 623 |
| Charging system | Alternator |
| Charging amps | 40 |
Frequently asked questions
How much horsepower does the John Deere 5103 have?
The John Deere 5103 delivers 50 HP.
What years was the John Deere 5103 produced?
The John Deere 5103 was produced in 2003-2008.
What transmission does the John Deere 5103 use?
The John Deere 5103 uses a SyncReverser transmission.
Is the John Deere 5103 4WD?
The John Deere 5103 is available in 2WD/4WD.