Cub Cadet 106
Power
10 hp
Production
1969-1971
Engine
1-cylinder
Transmission
Gear
Weight
620 lbs [281 kg]
Drive
2WD
From the same series:
Introduction
Production Information of Cub Cadet, 106
The production information of the tractor (106) includes details about its manufacturing.
| Garden tractor |
| Built in Louisville, Kentucky, USA |
| Manufacturer | Cub Cadet (a part of International Harvester) |
|---|
Dimension and Tires Information of Cub Cadet, 106
This section sums up the dimension and tires information of the tractor.
| Flange rear axle |
| Front axle | Cast-iron |
|---|---|
| Wheelbase | 43 inches [109 cm] |
| Shipping weight | 620 lbs [281 kg] |
| Height (steering wheel) | 39.75 inches [100 cm] |
| Length | 64 inches [162 cm] |
| Ground clearance | 6 inches [15 cm] |
| Width | 33.25 inches [84 cm] |
| Rear tread | 27 inches [68 cm] |
| Front tread | 27 inches [68 cm] |
| Lawn/turf front | 4.80/4.00-8 |
|---|---|
| Lawn/turf rear | 6-12 |
Engine Specifications of Cub Cadet, 106
Get the specifications for the engine and if different options are available.
| Air-cooled |
| 1-cylinder |
| Point gap | 0.020 inches [0.508 mm] |
|---|---|
| Sparkplug gap | 0.025 inches [0.635 mm] |
| Compression | 7:1 |
| Intake valve clearance | 0.010 inches (cold) [0.254 mm] |
| Idle RPM | 1000-3800 |
| Torque | 16.2 lb-ft [22.0 Nm] |
| Rated RPM | 3600 |
| Displacement | 391 cc [23.9 ci] |
| Power | 10 hp [7.5 kW] |
| Oil capacity | 1.5 qts [1.4 L] |
| Bore/Stroke | 3.25x2.875 inches [83 x 73 mm] |
| Sparkplug | Champion H-10 |
| Exhaust valve clearance | 0.020 inches (cold) [0.508 mm] |
| Starter volts | 12 |
| Torque RPM | 2200 |
Transmission Information of Cub Cadet, 106Y
Discover all variants of transmission available for this tractor model.
Transmission variants 1
| Type | Gear |
|---|---|
| Oil type | IH Hy-Tran |
| Oil capacity | 3.5 qts [3.3 L] |
| Gears | 3 forward and 1 reverse |
| IH Hy-Tran | |
| Clutch | 4.5-inch dry disc |
Transmission variants 2
| 3 | Gear shift |
|---|---|
| 1 | Clutch/brake |
| 2 | Throttle |
Transmission variants 3
| Optional creeper range is engaged by a lever on the left side of the drive line. |
| IH Hy-Tran | |
| Transmission | Creeper |
| 0.5 qts (creeper) [0.5 L] | |
| Oil capacity | 3.5 qts (trans) [3.3 L] |
| Gears | 6 forward and 2 reverse |
| Oil type | IH Hy-Tran |
| Clutch | 4.5-inch dry disc |
| 3-speed gear |
| 6-speed |
Mechanical Specs of Cub Cadet, 106Y
This section summarizes all mechanical information such as the brake system and other specifications.
| Two-wheel drive |
| Open operator station with padded seat. |
| Dry disc brakes |
| Steering | Manual |
|---|
Power Information of Cub Cadet, 106Y
Discover the power specifications and options available for this tractor model but also PTO (Power Take-off) information.
| Rear PTO | Transmission |
|---|---|
| Front PTO Type | 3600 |
| Rear PTO Type | 515 (0.937) |
| Clutch | Mechanical dry disc |
Three-Point Hitch of Cub Cadet, 106
Hitch category and rear/front lift capacity.
| Type | Cub Cadet three-point (optional) |
|---|
Electrical System of Cub Cadet, 106
Battery voltage, charging system and ground.
| Ground | Negative |
|---|---|
| Battery volts | 12 |
| Charging system | Generator |
| Charging amps | 15 |
Frequently asked questions
How much horsepower does the Cub Cadet 106 have?
The Cub Cadet 106 delivers 10 HP.
What years was the Cub Cadet 106 produced?
The Cub Cadet 106 was produced in 1969-1971.
What engine does the Cub Cadet 106 have?
The Cub Cadet 106 is powered by a 1-cylinder engine.
What transmission does the Cub Cadet 106 use?
The Cub Cadet 106 uses a Gear transmission.
How much does the Cub Cadet 106 weigh?
The Cub Cadet 106 weighs 620 lbs [281 kg].
Is the Cub Cadet 106 4WD?
The Cub Cadet 106 is available in 2WD.