Cub Cadet 126
Power
12 hp
Production
1969-1971
Engine
1-cylinder
Transmission
Gear
Weight
640 lbs [290 kg]
Drive
2WD
From the same series:
Introduction
Production Information of Cub Cadet, 126
The production information of the tractor (126) includes details about its manufacturing.
| Garden tractor |
| Built in Louisville, Kentucky, USA |
| Manufacturer | Cub Cadet (a part of International Harvester) |
|---|
Dimension and Tires Information of Cub Cadet, 126
This section sums up the dimension and tires information of the tractor.
| Flange rear axle |
| Front axle | Cast-iron |
|---|---|
| Wheelbase | 43 inches [109 cm] |
| Shipping weight | 640 lbs [290 kg] |
| Height (steering wheel) | 39.75 inches [100 cm] |
| Length | 64 inches [162 cm] |
| Ground clearance | 6 inches [15 cm] |
| Width | 36 inches [91 cm] |
| Rear tread | 27 inches [68 cm] |
| Front tread | 27 inches [68 cm] |
| Lawn/turf front | 4.80/4.00-8 |
|---|---|
| Lawn/turf rear | 23x8.50-12 |
Engine Specifications of Cub Cadet, 126
Get the specifications for the engine and if different options are available.
| Air-cooled |
| 1-cylinder |
| Point gap | 0.020 inches [0.508 mm] |
|---|---|
| Sparkplug gap | 0.025 inches [0.635 mm] |
| Compression | 6:1 |
| Intake valve clearance | 0.010 inches (cold) [0.254 mm] |
| Idle RPM | 1000-3800 |
| Torque | 19.6 lb-ft [26.6 Nm] |
| Rated RPM | 3600 |
| Displacement | 476 cc [29.07 ci] |
| Power | 12 hp [8.9 kW] |
| Oil capacity | 1.5 qts [1.4 L] |
| Bore/Stroke | 3.385x3.25 inches [86 x 83 mm] |
| Sparkplug | Champion H-10 |
| Exhaust valve clearance | 0.020 inches (cold) [0.508 mm] |
| Starter volts | 12 |
| Torque RPM | 2200 |
Transmission Information of Cub Cadet, 126Y
Discover all variants of transmission available for this tractor model.
Transmission variants 1
| Type | Gear |
|---|---|
| Oil type | IH Hy-Tran |
| Oil capacity | 3.5 qts [3.3 L] |
| Gears | 3 forward and 1 reverse |
| IH Hy-Tran | |
| Clutch | 4.5-inch dry disc |
Transmission variants 2
| 3 | Gear shift |
|---|---|
| 1 | Clutch/brake |
| 2 | Throttle |
Transmission variants 3
| Optional creeper range is engaged by a lever on the left side of the drive line. |
| IH Hy-Tran | |
| Transmission | Creeper |
| 0.5 qts (creeper) [0.5 L] | |
| Oil capacity | 3.5 qts (trans) [3.3 L] |
| Gears | 6 forward and 2 reverse |
| Oil type | IH Hy-Tran |
| Clutch | 4.5-inch dry disc |
| 3-speed gear |
| 6-speed |
Mechanical Specs of Cub Cadet, 126Y
This section summarizes all mechanical information such as the brake system and other specifications.
| Two-wheel drive |
| Open operator station with padded seat. |
| Dry disc brakes |
| Steering | Manual |
|---|
Power Information of Cub Cadet, 126Y
Discover the power specifications and options available for this tractor model but also PTO (Power Take-off) information.
| Rear PTO | Transmission |
|---|---|
| Front PTO Type | 3600 |
| Rear PTO Type | 515 (0.937) |
| Clutch | Mechanical dry disc |
Three-Point Hitch of Cub Cadet, 126
Hitch category and rear/front lift capacity.
| Type | Cub Cadet three-point (optional) |
|---|
Electrical System of Cub Cadet, 126
Battery voltage, charging system and ground.
| Ground | Negative |
|---|---|
| Battery volts | 12 |
| Charging system | Generator |
| Charging amps | 15 |
Frequently asked questions
How much horsepower does the Cub Cadet 126 have?
The Cub Cadet 126 delivers 12 HP.
What years was the Cub Cadet 126 produced?
The Cub Cadet 126 was produced in 1969-1971.
What engine does the Cub Cadet 126 have?
The Cub Cadet 126 is powered by a 1-cylinder engine.
What transmission does the Cub Cadet 126 use?
The Cub Cadet 126 uses a Gear transmission.
How much does the Cub Cadet 126 weigh?
The Cub Cadet 126 weighs 640 lbs [290 kg].
Is the Cub Cadet 126 4WD?
The Cub Cadet 126 is available in 2WD.