John Deere 2210
Power
23 hp
Production
2003-2006
Engine
Diesel, 3-cylinder
Transmission
Hydrostatic
Drive
4WD
From the same series:
Introduction
Production Information of John Deere, 2210
The production information of the tractor (2210) includes details about its manufacturing.
| Sub-Compact Utility tractor |
| Built in Augusta, Georgia, USA |
| Manufacturer | John Deere |
|---|
Dimension and Tires Information of John Deere, 2210
This section sums up the dimension and tires information of the tractor.
| Front tread | 31.1 inches [78 cm] |
|---|---|
| Wheelbase | 57 inches [144 cm] |
| Height (ROPS) | 78.6 inches [199 cm] |
| Height (hood) | 41.8 inches [106 cm] |
| Length | 104 inches [264 cm] |
| Rear tread | 35.3 inches [89 cm] |
| Clearance (front axle) | 7.7 inches [19 cm] |
| Width | 47.9 inches [121 cm] |
| Ag front | 18x8.50-10 |
|---|---|
| Industrial front | 18x8.50-10 |
| Lawn/turf rear | 26x12.00-12 |
| Ag rear | 26x12.00-12 |
| Industrial rear | 26x12.00-12 |
| Lawn/turf front | 18x8.50-10 |
Engine Specifications of John Deere, 2210
Get the specifications for the engine and if different options are available.
| Yanmar 3TNE74 |
| Liquid-cooled |
| Diesel |
| 3-cylinder |
| Starter power | 1.5 hp [1.1 kW] |
|---|---|
| Starter volts | 12 |
| Power (gross) | 23 hp [17.2 kW] |
| Oil capacity | 2.1 qts [2.0 L] |
| Air cleaner | Dry |
| Pre-heating | Coolant heater OptOptional |
| Fuel system | Indirect injection |
| Displacement | 61.4 ci [1.0 L] |
| Power (net) | 22.5 hp [16.8 kW] |
| Bore/Stroke | 2.91x3.07 inches [74 x 78 mm] |
| Starter | Electric |
| Coolant capacity | 3.1 qts [2.9 L] |
| Rated RPM | 3000 |
| Compression | 23.5:1 |
Transmission Information of John Deere, 2210Y
Discover all variants of transmission available for this tractor model.
Transmission variants 1
| Type | Hydrostatic |
|---|---|
| Gears | Infinite forward and reverse (2-range) |
| Oil capacity | 13.6 qts [12.9 L] |
Mechanical Specs of John Deere, 2210Y
This section summarizes all mechanical information such as the brake system and other specifications.
| Four-wheel drive |
| Two-post fixed ROPS. |
| Power steering |
| Final drives | Spur gear |
|---|---|
| Differential lock | Mechanical rear |
Power Information of John Deere, 2210Y
Discover the power specifications and options available for this tractor model but also PTO (Power Take-off) information.
| Engine RPM | 2100@2600 |
|---|---|
| Rear PTO | Independent |
| Mid PTO | Independent |
| Engine RPM | 540@2600 |
| Clutch | Hydraulic wet disc |
| Clutch | Hydraulic wet disc *Mid PTO shared clutch with rear PTO. |
| Rear PTO Type | 540 (1.375) |
Hydraulics Specifications of John Deere, 2210
Hydraulic system type, pressure, pump flow and valves.
| Steering flow | 2.5 gpm [9.5 lpm] |
|---|---|
| Type | Open center |
| Pump flow | 3 gpm [11.4 lpm] |
| Mid valves | 2 |
| Capacity | 3.4 gal [12.9 L] |
| Total flow | 5.5 gpm [20.8 lpm] |
| Pressure | 1987 psi [137.0 bar] |
Three-Point Hitch of John Deere, 2210
Hitch category and rear/front lift capacity.
| Rear Type | I *Limited |
|---|---|
| Rear lift (at 24"/610mm) | 700 lbs [317 kg] |
Electrical System of John Deere, 2210
Battery voltage, charging system and ground.
| Ground | Negative |
|---|---|
| Battery volts | 12 |
| Battery CCA | 435 |
| Charging system | Alternator |
| Charging amps | 20 |
Frequently asked questions
How much horsepower does the John Deere 2210 have?
The John Deere 2210 delivers 23 HP.
What years was the John Deere 2210 produced?
The John Deere 2210 was produced in 2003-2006.
What engine does the John Deere 2210 have?
The John Deere 2210 is powered by a Diesel, 3-cylinder engine.
What transmission does the John Deere 2210 use?
The John Deere 2210 uses a Hydrostatic transmission.
Is the John Deere 2210 4WD?
The John Deere 2210 is available in 4WD.