John Deere 4410 tractor

John Deere 4410

Power

34 hp

Production

2002-2004

Engine

Diesel, 3-cylinder

Transmission

EPowrReverser

Drive

4WD

From the same series:

4310
4510

Introduction

Production Information of John Deere, 4410

The production information of the tractor (4410) includes details about its manufacturing.

Compact Utility tractor
Built in Augusta, Georgia, USA
ManufacturerJohn Deere

Dimension and Tires Information of John Deere, 4410

This section sums up the dimension and tires information of the tractor.

Wheelbase68 inches [172 cm]
Ground clearance13.4 inches [34 cm]
Length117 inches [297 cm]
Width50 inches [127 cm]
Ag front7.00-14
Ag rear11.2-24

Engine Specifications of John Deere, 4410

Get the specifications for the engine and if different options are available.

Yanmar 3TNE88
Liquid-cooled
Diesel
3-cylinder
Coolant capacity6 qts [5.7 L]
Air cleanerDry
Compression18.5:1
Idle RPM1000-2810
Rated RPM2600
Displacement81.2 ci [1.3 L]
Power (gross)34.6 hp [25.8 kW]
Bore/Stroke3.23x3.31 inches [82 x 84 mm]
Oil capacity4.5 qts [4.3 L]
Starter power1.9 hp [1.4 kW]
Starter volts12

Transmission Information of John Deere, 4410Y

Discover all variants of transmission available for this tractor model.

Transmission variants 1

Four gears (1-4) in three ranges (A-C) with reverser lever. Gears are synchronized and may be shifted on the move using the clutch. Tractor must be stopped to shift ranges. Forward/reverse direction changes may be done on the move, without the clutch, by using the reverser lever.
TransmissionEPowrReverser
Oil capacity25.2 qts [23.8 L]
TypePower shuttle
Gears12 forward and reverse

Transmission variants 2

Three-range hydrostatic transmission with foot pedals and cruise control. Tractor must be stopped to shift ranges. Automotive cruise control option allows set speed to be adjusted with rocker switch. SpeedMatch option allows a maximum speed to be set and full pedal travel used to achive that speed. LoadMatch option prevents the tractor from stalling during heavy loads. The MotionMatch option enables the acceleration rate to be set to fast or slow.
TransmissionEHydro
Oil capacity27.2 qts [25.7 L]
TypeHydrostatic
GearsInfinite forward and reverse (3-range)
12-speed power shuttle
Hydrostatic

Mechanical Specs of John Deere, 4410Y

This section summarizes all mechanical information such as the brake system and other specifications.

Four-wheel drive
Wet disc brakes
Two-post fixed ROPS. Two-post folding ROPS optional.
SteeringPower
Final drivesSpur gear
Differential lockMechanical rear

Power Information of John Deere, 4410Y

Discover the power specifications and options available for this tractor model but also PTO (Power Take-off) information.

Rear PTOIndependent
Mid PTOIndependent OptOptional
Engine RPM540@2600
ClutchWet disc
Mid PTO Type2100
Rear PTO Type540 (1.375)

Hydraulics Specifications of John Deere, 4410

Hydraulic system type, pressure, pump flow and valves.

Total flow13.9 gpm [52.6 lpm]
TypeOpen center
Valves5
Pressure2500 psi [172.4 bar]
Capacity6.3 gal (gear) [23.8 L]
Steering flow5.3 gpm [20.1 lpm]
Pump flow8.6 gpm [32.6 lpm]
6.8 gal (hydro) [25.7 L]

Three-Point Hitch of John Deere, 4410

Hitch category and rear/front lift capacity.

Rear TypeI
Rear lift (at 24"/610mm)2,200 lbs [997 kg]

Electrical System of John Deere, 4410

Battery voltage, charging system and ground.

GroundNegative
Battery CCA500
55 (optional)
Charging systemAlternator
Battery volts12
Charging amps40

Frequently asked questions

How much horsepower does the John Deere 4410 have?

The John Deere 4410 delivers 34 HP.

What years was the John Deere 4410 produced?

The John Deere 4410 was produced in 2002-2004.

What engine does the John Deere 4410 have?

The John Deere 4410 is powered by a Diesel, 3-cylinder engine.

What transmission does the John Deere 4410 use?

The John Deere 4410 uses a EPowrReverser transmission.

Is the John Deere 4410 4WD?

The John Deere 4410 is available in 4WD.

Compare the John Deere 4410 with another model